To replace a Toyota Supra coolant hose, let the engine cool, drain enough coolant, remove the old hose and clamps, fit the correct new hose with new clamps, then refill and bleed the system. Hose layout and part numbers differ between Supra generations, so use the service manual and match parts to your VIN. Related: how to add coolant to a Toyota Supra.
Gather Your Tools and Safety Gear

You need pliers or a hose clamp tool, a drain pan, new hoses and clamps, coolant, distilled water if you mix it, gloves and eye protection.
Drain the Cooling System Properly
Work on a cold engine. Drain the coolant into a pan and dispose of it according to local rules, because it is toxic.
How to Replace the Toyota Supra Coolant Hose
- Release the clamp and twist the hose gently to break the seal.
- Note the routing, or take a photo, before removing it.
- Pull the hose off the fitting.
Drain Cooling System Thoroughly
Catch the remaining coolant as the hose comes off.
Inspect Hose Clamps
Replace clamps that are rusty or weak.
Clean Fitting Surfaces
Wipe the fittings clean so the new hose seals properly.
Check Your Fittings for Damage

Look for cracks and corrosion on the fittings. Replace a damaged part.
Select Compatible Replacement Hoses for Your Supra
Match the hose to your model year and engine using the VIN or the part number from a dealer.
Identify Hose Specifications
Check the diameter, length, shape and any quick-connect ends. Use the old hose as a reference, but trust the part number.
OEM Vs. Aftermarket Options
OEM hoses fit as designed. Aftermarket hoses can work, but verify fitment and quality first.
Verify Fitment Compatibility
Fitment can vary across Supra generations, so confirm it before you drain the system.
Install New Hoses With Proper Clamps
Push the hose fully onto the fitting, fit the clamp in the right place, and tighten it firmly but not so hard that it cuts the hose.
Refill Your Coolant

Fill with the coolant listed in the owner’s manual, and follow the bleeding procedure to remove air.
Start the Engine: What to Check for Leaks?
Run the engine to temperature, watch the gauge, and look at every joint you touched. Check again after the engine cools.
Perform Final Checks and Maintenance Tips
- Top up the coolant when cold.
- Re-check clamps after a few drives.
- Replace other old hoses at the same time if they are soft or cracked.
Related reading:
- How to Fix Toyota Supra Coolant Leak: Step-by-Step Guide
- How to Replace Toyota Supra Water Pump: Step-by-Step Guide
Frequently Asked Questions
How Do You Replace a Coolant Hose?
Drain the coolant, remove the old hose and clamps, install the new hose and clamps, then refill and bleed.
How Long Does It Take to Replace a Coolant Hose?
It depends on the hose and access. Ask a shop for an estimate, and allow time for bleeding.
How Much Is a Coolant Flush for a Toyota Supra?
Prices vary by shop and region. Ask for a quote.
How Expensive Is It to Replace a Coolant Hose?
Cost depends on the hose, parts and labor rates. Ask for a quote.
Conclusion
Use the right hose and clamps, refill with the correct coolant, and bleed the system.
